{"product_id":"75kva-able-diesel-generator-pl75x3","title":"75kVA ABLE Diesel Generator PL75X3","description":"\u003cp\u003eThe PL75X3 is a 75kVA three phase diesel generator rated 75kVA (60kW) prime (PRP) and 82kVA (66kW) standby (ESP) at 415V, 50Hz and a power factor of 0.8. It is powered by a Xinchai AK41LD31, a four cylinder, water-cooled diesel of 4.1 litres running at 1500 rpm, and drives a four-pole brushless synchronous alternator with AVR. Starting is electric with the batteries included, and protection is an IP67-enclosed RCD plus over current protection.\u003c\/p\u003e\n\u003ch3\u003eKey features\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eThe engine has direct injection and a mechanical governor, so engine speed is regulated mechanically rather than electronically.\u003c\/li\u003e\n\u003cli\u003eThe alternator is wound in 100% copper, with class H insulation, IP23 protection and voltage held within ±0.5%, so the output stays steady as loads change.\u003c\/li\u003e\n\u003cli\u003eThe ComAp AMF controller has a two-wire remote start input, so a switch or external controller can start the set.\u003c\/li\u003e\n\u003cli\u003eThe lockable canopy is sound deadened, with a weather-resistant powder coat and stainless steel fittings.\u003c\/li\u003e\n\u003cli\u003eTwo 32A and one 20A three phase outlets and one 15A single phase outlet are rated IP66 (dust tight and protected against powerful water jets), and hardwire terminals are fitted for a fixed connection.\u003c\/li\u003e\n\u003cli\u003eMine site ready bunding is specified, so fuel spills are contained on sites that need it.\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003eThe tank holds 420 litres and noise is 67 dB(A) at 7 m. The engine is rated 74.0 kW prime and 81.0 kW standby, and a coolant heater is needed when the temperature is below 5°C.\u003c\/p\u003e\n\u003ch3\u003eWhat it will run\u003c\/h3\u003e\n\u003cp\u003eAt 60kW prime the PL75X3 has a rated current of about 105A per phase, and at a power factor of 0.8 the loads should be added up in kW as well as kVA. Frame the choice around the combined loads of the site rather than single appliances. Typically it suits the refrigeration, motors, pumps and lighting of a factory, a warehouse or a cold chain facility. Stagger the starts: the largest motor first, then the rest, because motors draw several times their running current as they start. Keep the three phases balanced. Check the compliance plates for each machine's running and starting power. An electrician or engineer should review the site load before the set is specified, and a licensed electrician should make the switchboard connection. Send us your load list and we will help you check the set against your site.\u003c\/p\u003e\n\u003cp\u003eThe PL75X3 suits factories, warehouses, cold chain facilities and mine camps, either standing by for a mains outage or supplying a site with a variable load as prime power.\u003c\/p\u003e\n\u003ch3\u003eKey specifications\u003c\/h3\u003e\n\u003cul style=\"list-style-position: outside; padding-left: 1.5em; margin-left: 0;\"\u003e\n\u003cli\u003e\n\u003cstrong\u003eOutput:\u003c\/strong\u003e 75kVA (60kW) prime, 82kVA (66kW) standby @ 0.8PF\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eRated current:\u003c\/strong\u003e 105 Amps per phase (prime)\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eEngine:\u003c\/strong\u003e Xinchai AK41LD31 diesel, 1500rpm, water cooled\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eAlternator:\u003c\/strong\u003e Three phase 4-pole brushless synchronous alternator with AVR\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eController:\u003c\/strong\u003e ComAp AMF20, two-wire remote start\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eStart type:\u003c\/strong\u003e 24 volt electric, batteries included\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003ePhase \/ voltage:\u003c\/strong\u003e Three phase, 415V, 50Hz\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eFuel:\u003c\/strong\u003e Diesel\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eFuel tank:\u003c\/strong\u003e 420 L\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eFuel use:\u003c\/strong\u003e 19 L\/hr at prime load\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eRun time:\u003c\/strong\u003e 22 hrs continuous at prime load\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eNoise level:\u003c\/strong\u003e 67 dB(A) @ 7m\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eOutlets:\u003c\/strong\u003e 2 x 32 Amp and 1 x 20 Amp three phase and 1 x 15 Amp single phase IP66 outlets\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eHardwire terminals:\u003c\/strong\u003e Yes\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eProtection:\u003c\/strong\u003e RCD to Australian Standards (IP67 enclosed), over current protection\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eCanopy:\u003c\/strong\u003e Lockable, sound deadened, weather-resistant powder coat, stainless steel fittings\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eMine spec:\u003c\/strong\u003e Mine site ready bunding\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eDimensions (L x W x H):\u003c\/strong\u003e 242 x 95 x 164 cm\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eWeight:\u003c\/strong\u003e 1,580 kg\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eWarranty:\u003c\/strong\u003e 12 months or 1,000 hours\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eEngine configuration:\u003c\/strong\u003e 4 cylinder, 105 x 118 mm bore and stroke, 4.1 L, compression ratio 18.0, direct injection, mechanical governor\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eEngine output:\u003c\/strong\u003e 74.0 kWm prime, 81.0 kWm standby\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eEngine oil capacity:\u003c\/strong\u003e 7.5 L\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eAlternator model:\u003c\/strong\u003e PL2D-3\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eAlternator construction:\u003c\/strong\u003e 4 pole, 100% copper windings, 2\/3 winding pitch, insulation class H, IP23, shunt self-excitation\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eVoltage regulation:\u003c\/strong\u003e ±0.5%\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eProtection class:\u003c\/strong\u003e IP54\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eCoolant heater:\u003c\/strong\u003e Needed when the temperature is below 5°C\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eRating test conditions:\u003c\/strong\u003e 25°C ambient, 100 m altitude, 30% relative humidity\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eStandards:\u003c\/strong\u003e CE, ISO 8528-5:2005, AS 3000-2018, AS 3010-2017\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003ePart of the ABLE Power range at Gen4Sale.\u003c\/p\u003e","brand":"ABLE","offers":[{"title":"Default Title","offer_id":67546748289215,"sku":"PL75X3","price":18868.0,"currency_code":"AUD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0678\/7409\/5295\/files\/ABLE-PL75X3.jpg?v=1791155381","url":"https:\/\/gen4sale.com.au\/products\/75kva-able-diesel-generator-pl75x3","provider":"Gen4Sale","version":"1.0","type":"link"}