{"product_id":"10kva-able-diesel-generator-pl9d1","title":"10kVA ABLE Diesel Generator PL9D1","description":"\u003cp\u003eThe PL9D1 is a 10kVA single phase diesel generator rated 9kVA (9kW) prime (PRP) and 10kVA (10kW) standby (ESP) at 240V, 50Hz and a power factor of 1.0. It is powered by a YangDong YD385D, a three cylinder, water-cooled diesel running at 1500 rpm, driving a four-pole brushless alternator with AVR. Starting is electric at 12 volts with the battery included, and protection is an IP67-enclosed RCD plus over current protection.\u003c\/p\u003e\n\u003ch3\u003eKey features\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eThe YD385D is naturally aspirated with direct injection and a mechanical governor, so there is no turbocharger to maintain and engine speed is held at 1500 rpm.\u003c\/li\u003e\n\u003cli\u003eThe alternator has 100% copper windings, class H insulation and voltage regulation of ±0.5%, which keeps the output voltage steady as the load changes.\u003c\/li\u003e\n\u003cli\u003eThe ComAp AMF controller has a two-wire remote start input, so an external switch or controller can start the set.\u003c\/li\u003e\n\u003cli\u003eThe canopy locks, is sound deadened to cut engine noise, and has a weather-resistant powder coat with stainless steel fittings.\u003c\/li\u003e\n\u003cli\u003eMine site ready bunding is part of the specification, for sites that need fuel spills contained.\u003c\/li\u003e\n\u003cli\u003eOperating conditions are specified from -25°C to 45°C ambient (a coolant heater is needed below 5°C), with humidity below 80% and altitude below 1000 m, so you can check them against your site.\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003eThe tank holds 70 litres. Outlets are 3 x 15A and 1 x 32A, with hardwire terminals for a fixed connection. Noise is about 65 dB(A) at 7 m. Design standards are CE, ISO 8528-5:2005, AS 3000-2018 and AS 3010-2017.\u003c\/p\u003e\n\u003ch3\u003eWhat it will run\u003c\/h3\u003e\n\u003cp\u003eAt 240V the prime rating works out to about 37.5A. Typically that covers lighting, fridges and freezers, a bore or pressure pump, power tools and a split-system air conditioner, as long as the starting loads do not all arrive at once. Pumps, compressors and air conditioners draw several times their running current as they start, so leave headroom for your largest motor. Read each appliance's running and starting power from its compliance plate, then add them up. Size against the prime rating if the set will run regularly: prime allows unlimited annual hours on a variable load, with 10% overload for 1 hour in every 12, while standby is limited to 500 hours a year, with no overload. A home backup connection goes through an inlet and changeover switch installed by a licensed electrician. Send us your load list and we will work through the sizing with you.\u003c\/p\u003e\n\u003cp\u003eThe PL9D1 suits farms, workshops, small commercial premises and building sites, and can back up a home through an outage. Its prime and standby ratings cover regular running as well as emergency use.\u003c\/p\u003e\n\u003ch3\u003eKey specifications\u003c\/h3\u003e\n\u003cul style=\"list-style-position: outside; padding-left: 1.5em; margin-left: 0;\"\u003e\n\u003cli\u003e\n\u003cstrong\u003eOutput:\u003c\/strong\u003e 9kVA (9kW) prime, 10kVA (10kW) standby @ 1.0PF\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eRated current:\u003c\/strong\u003e 37 Amps (prime)\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eEngine:\u003c\/strong\u003e YangDong YD385D three-cylinder diesel, 1500rpm, water cooled\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eAlternator:\u003c\/strong\u003e Single phase 4-pole brushless synchronous alternator with AVR\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eController:\u003c\/strong\u003e ComAp AMF20, two-wire remote start\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eStart type:\u003c\/strong\u003e 12 volt electric, battery included\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003ePhase \/ voltage:\u003c\/strong\u003e Single phase, 240V, 50Hz\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eFuel:\u003c\/strong\u003e Diesel\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eFuel tank:\u003c\/strong\u003e 70 L\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eFuel use:\u003c\/strong\u003e 2.5 L\/hr at prime load\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eRun time:\u003c\/strong\u003e 28 hrs continuous at prime load\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eNoise level:\u003c\/strong\u003e 65 dB(A) @ 7m\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eOutlets:\u003c\/strong\u003e 3 x 15 Amp and 1 x 32 Amp outlets\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eHardwire terminals:\u003c\/strong\u003e Yes\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eProtection:\u003c\/strong\u003e RCD to Australian Standards (IP67 enclosed), over current protection\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eCanopy:\u003c\/strong\u003e Lockable, sound deadened, weather-resistant powder coat, stainless steel fittings\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eMine spec:\u003c\/strong\u003e Mine site ready bunding\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eDimensions (L x W x H):\u003c\/strong\u003e 141 x 72 x 113 cm\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eWeight:\u003c\/strong\u003e 600 kg\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eWarranty:\u003c\/strong\u003e 12 months or 1,000 hours\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003ePrime (PRP) limits:\u003c\/strong\u003e Variable load, unlimited annual hours, 10% overload for 1 hour in every 12\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eStandby (ESP) limits:\u003c\/strong\u003e 500 hours a year, up to 300 hours at a time, no overload\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eEngine configuration:\u003c\/strong\u003e 3 cylinder, 85 x 90 mm bore and stroke, 1.532 L, 18:1 compression, naturally aspirated, direct injection, mechanical governor\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eEngine output:\u003c\/strong\u003e 11.0 kWm prime, 12.1 kWm standby\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eEngine capacities:\u003c\/strong\u003e Oil 4.5 L, coolant 3.5 L\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eAlternator model:\u003c\/strong\u003e PL1E-1\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eAlternator construction:\u003c\/strong\u003e 4 pole, 100% copper windings, 2\/3 winding pitch, insulation class H, IP23, shunt self-excitation\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eVoltage regulation:\u003c\/strong\u003e ±0.5%\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eProtection class:\u003c\/strong\u003e IP54\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eOperating conditions:\u003c\/strong\u003e Ambient -25 to 45°C (coolant heater needed below 5°C), humidity below 80%, altitude below 1000 m\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eRating test conditions:\u003c\/strong\u003e 25°C ambient, 100 m altitude, 30% relative humidity\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eDesign standards:\u003c\/strong\u003e CE, ISO 8528-5:2005, AS 3000-2018, AS 3010-2017\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003ePart of the ABLE Power range at Gen4Sale.\u003c\/p\u003e","brand":"ABLE","offers":[{"title":"Default Title","offer_id":67546745438399,"sku":"PL9D1","price":7378.0,"currency_code":"AUD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0678\/7409\/5295\/files\/ABLE-PL9D1.jpg?v=1791155216","url":"https:\/\/gen4sale.com.au\/products\/10kva-able-diesel-generator-pl9d1","provider":"Gen4Sale","version":"1.0","type":"link"}